Feltec Epoxy Coat


Product Description

FELTEC EPOXY COAT is a 2-pack solvent-based epoxy coating designed for use on old and new concrete and steel substrates. The finishing is a high gloss finish with excellent adhesion onto properly prepared concrete, and good abrasion resistance. It has good resistance to alkali, solvents, water and salt.


Packing Size

5kg/set.

Theoretical Coverage

40m²/5L
 Color Options:
Finish Glossy
Colour Refer to colour Card
Flash Point Part A : 23°C
Part B : 26°C
No. Of Components
Pot – Life 28ºC 5 – 6 hours

 

Primary used in floor surfaces subjected to chemical and mechanical exposure. Suitable for food processing plants, waste disposal facilities, pulp & paper mils, refineries, and other industrial sectors where a general chemical resistance and protection is required.

Recommended Dry film Thickness Wet : 100 microns
Dry : 50 microns
Theoretical Coverage 40m² per 5L set
Volume Solids Approx. 50%
No Of Coats 2 – 3 coats
When computing actual coverage, please allow for application losses, surface irregularities

 

Application Method Brush/ Roller/Spray Gun
Drying Time (at 28ºc) Foot Traffic : 16 hours
Full – Traffic Load : 1 day
Recoating Interval Min : 8 hours
Thinner / cleaner Federal General Thinner MO-316
Mixing Ratio (by volume) 4:1 (resin : cure).
Surface Preparation Surfaces must be dry and free of all contaminants. All blasted surfaces must coated immediately.

 

Storage Feltec Epoxy Coat material should be stored below 30°c out of direct sunlight and rain. All containers should remain sealed until ready to use.
Handling Handle with care. Stir well before use.
Shelf life 1 year from shipment date when stored indoors at 30°X
Packing Size 5 litres/set : 4 litres Part A (Resin) & 1 litres Part B (Activator)